I originally posted this in general and then saw the sticky saying your not supposed to post questions there. Update before I even bothered to submit this last section: I installed CWM via fastboot, which then enabled me to actually enter a recovery, which then let me install the JB bootloader update and thusly HairyBean. After restarting with the power + voldown button, let go, and hit volume up (press vol up in 5 seconds to enter RCK), it waits a second, then restarts. I see now based on the skaforey's post that pressing volume up should be the way into recovery, however as I stated to him, it simply resets the device. Sorry, I neglected to mention I actually have been doing all of my work based on these very instructions from the androwook page, and it is where I ran into this issue in the first place. Okay, I did that too, but it just resets the device and if I do nothing it loads into Android. Go to post 2 of the androwook thread and follow instructions there for updating from ics
As soon as the screen shows something press volume up, that will start recovery. Hold vol down+power and when it vibrates, let go of power. When I go into the recovery screen, it only shows the wipe data, fastboot, and load android, there's nothing to get into TWRP. My problem now is, I've been trying to initiate the install of both the JB bootloader and Hairybean TWRP Updater (normal), but no matter what I seem to do, I can't seem to get it to be installed. Okay, thanks, it was working the whole time then. the universal naked drivers in the development section should work if your pc is looking for drivers for the device If you look in device manager on your PC you may see it near the top of the devices. I haven't done anything previously on my Prime other than unlocking it, which was a while ago, but I didn't do anything past that, so I'm not sure what could be going on, it is not bricked and works completely fine other than not being able to get into the fastboot mode. The computer doesn't recognize it at all with it stuck at this screen, and I assume there is supposed to be some sort of new view that comes up. I let it sit for a while to see if it was going to do something, but it doesn't. Starting in Fastboot Not working - Eee Pad Transformer Prime Q&A, Help & Troubleshooting I'm trying to update from an ICS bootloader to a JB one, however when I try to go through the process of starting up in the Fastboot mode, as soon as I hit the Vol Up key, it just sits there with the text saying it is starting the Fastboot mode.
0 kommentar(er)
